Thingiverse
Anycubic 4Max Extruder Stepper Motor Cooler NEMA 17
by Sp4wN
124
Downloads
87
Likes
2
Makes
Anycubic 4Max has issues with extruding at least my 4Max does.
First figured out that the tension spring needs to be dialed in good, this solved a lot of my extruding problems but I noticed in long prints it still had issues with clicking extruder, the extruder stepper was getting hot, especially in the closed environment of 4Max, also noticed that the clicking got less when I open the door of the printer.
Measured the VREF and it was 0.86 volt which is not that high, lowered that little b
First figured out that the tension spring needs to be dialed in good, this solved a lot of my extruding problems but I noticed in long prints it still had issues with clicking extruder, the extruder stepper was getting hot, especially in the closed environment of 4Max, also noticed that the clicking got less when I open the door of the printer.
Measured the VREF and it was 0.86 volt which is not that high, lowered that little b
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in