Idle Pulley Extension For Kossel Motors On The Top Configuration And Also a Belt Tensioner

This is an idle pulley extension for Kossel motors on the top config.
Extension distance : 95mm
Which means it can reduce 95mmX2 belt length.
It also functions as a belt tensioner.

Print 3 copies for one kossel,
and you'll need:
1. 3x M3 hex nuts and 3x18mm M3 Screw for idlers
2. 6x M3 hex nuts and 6x 24mm(or longer) screws for connection of the two pieces


For durability , PETG is highly recommended.
PLA is ok for a short turn use, but it will crack over time.