Thingiverse
Magnetic Laser Level Holder
by Almantle
50
Downloads
42
Likes
0
Makes
A magnetic laser level holder for lasers that don't come with one.
Theres also a hole in the top for a screw if you need to screw the holder to non magnetic surfaces. On the bottom is a countersunk hole to use a 6mm (1/4) roofing bolt to attach the level.
The holes for the magnets were very tight & headed a bit of sanding to get a snug fit (may want to increase size bu 1%) the magnets were then glued in. The magnets used were 15mm diameter & 2mm thick.
Could also be used to mount a camera
Theres also a hole in the top for a screw if you need to screw the holder to non magnetic surfaces. On the bottom is a countersunk hole to use a 6mm (1/4) roofing bolt to attach the level.
The holes for the magnets were very tight & headed a bit of sanding to get a snug fit (may want to increase size bu 1%) the magnets were then glued in. The magnets used were 15mm diameter & 2mm thick.
Could also be used to mount a camera
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in