Thingiverse
CalibrationCube
by xpix
9
Downloads
4
Likes
0
Makes
Hello Friends,
the normal xyzCalibrationCube was not enough for me, because I also wanted to test holes and threads. Here is my cube that has already served me very well in setting up my 3D printer.
The edge length is 20mm with a bevel of 1mm.
2 holes on the XY side with 10.05 and 8.05 mm diameter, take the shaft of a drill (8 and 10mm) and insert it into the hole. It should fit perfectly without wobbling. There is also an M8x1.25 thread on the Z-side. Here you should be able to screw in
the normal xyzCalibrationCube was not enough for me, because I also wanted to test holes and threads. Here is my cube that has already served me very well in setting up my 3D printer.
The edge length is 20mm with a bevel of 1mm.
2 holes on the XY side with 10.05 and 8.05 mm diameter, take the shaft of a drill (8 and 10mm) and insert it into the hole. It should fit perfectly without wobbling. There is also an M8x1.25 thread on the Z-side. Here you should be able to screw in
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in