Thingiverse
Evolve GTX Stand and belt protection
by Ly3s
29
Downloads
23
Likes
0
Makes
This is a protective stand for the motors of evolve gtx street electric longboards.
It's a snap fit, no screws are required. And it clips directly on the pignon motor belt protective plastic part.
It allows the skateboard to be put horizontally against a wall without damaging the electrical motors nor sliding off the wall.
I hope you'll enjoy those pieces!
It's a snap fit, no screws are required. And it clips directly on the pignon motor belt protective plastic part.
It allows the skateboard to be put horizontally against a wall without damaging the electrical motors nor sliding off the wall.
I hope you'll enjoy those pieces!
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in