Thingiverse
TOUGHOOK CABLE RISER for Electric Skateboard
by toughook
20
Downloads
19
Likes
0
Makes
UPDATED - DECEMBER 2018
Toughook Cable Riser.
Plug In, and then hide your phase wires into your battery enclosure.
Designed for 4mm Female Bullet Connectors, but you can drill out the holes to take 5mm or 5.5mm Bullets depending on your motors. (You may need to run a 5mm drill through the Bullet Holes anyway to free up the hole for the connectors anyway depending on how accurate your printer is).
There are 2x extra rectangular holes to run your motor sensor cables through without the
Toughook Cable Riser.
Plug In, and then hide your phase wires into your battery enclosure.
Designed for 4mm Female Bullet Connectors, but you can drill out the holes to take 5mm or 5.5mm Bullets depending on your motors. (You may need to run a 5mm drill through the Bullet Holes anyway to free up the hole for the connectors anyway depending on how accurate your printer is).
There are 2x extra rectangular holes to run your motor sensor cables through without the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in