Thingiverse
Screwdriver Holder with Type (TX, PH, PZ etc.) and Size Labels
door zeropage
1.3k
Downloads
926
Likes
8
Makes
A phalanx of ridiculously overengineered screwdriver holders that were initially designed for my "Wera Kraftform 300" set. I am pretty confident that the holders will fit other brands too. Check the holes' diameters below to see if the holders will fit your screwdrivers.
**Diameter of through-holes in model**
• PH3, PZ3, TX40: 8.6 mm, for 8 mm shaft
• PH2, PZ2, TX30: 6.6 mm, for 6 mm shaft
• PH1, PZ1, TX20: 5.1 mm, for 4.5 mm shaft
• FB2.5: 3.1 mm, for 2.5 mm shaft
• FB3.0: 3.6 mm, for 3.0 mm shaft
• FB3.5, TX8: 4.05 mm, for 3.45 mm shaft
• FB4.0, TX9, TX10, TX 15: 4.6 mm, for 4.0 mm shaft
• FB6.5: 8.6 mm, for 6.5 mm shaft. NB: The blade is 8 mm wide!
• TX25: 5.6mm, for 5 mm shaft
*FB=flat-blade, slotted
**External hexagon (EH)**
These drivers have a much bigger tip than shaft to accommodate nuts. Hence, the shaft diameter isn't relevant but the diameter of the tip. Figures given are tip diameters.
• EH5.0, EH5.5: 9.1mm
• EH6.0: 10.2mm
• EH7.0: 11.2mm
• EH8.0: 12.2
**Diameter of through-holes in model**
• PH3, PZ3, TX40: 8.6 mm, for 8 mm shaft
• PH2, PZ2, TX30: 6.6 mm, for 6 mm shaft
• PH1, PZ1, TX20: 5.1 mm, for 4.5 mm shaft
• FB2.5: 3.1 mm, for 2.5 mm shaft
• FB3.0: 3.6 mm, for 3.0 mm shaft
• FB3.5, TX8: 4.05 mm, for 3.45 mm shaft
• FB4.0, TX9, TX10, TX 15: 4.6 mm, for 4.0 mm shaft
• FB6.5: 8.6 mm, for 6.5 mm shaft. NB: The blade is 8 mm wide!
• TX25: 5.6mm, for 5 mm shaft
*FB=flat-blade, slotted
**External hexagon (EH)**
These drivers have a much bigger tip than shaft to accommodate nuts. Hence, the shaft diameter isn't relevant but the diameter of the tip. Figures given are tip diameters.
• EH5.0, EH5.5: 9.1mm
• EH6.0: 10.2mm
• EH7.0: 11.2mm
• EH8.0: 12.2
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
