Thingiverse
Filament / Extruder Guide
by Filboyt
457
Downloads
242
Likes
1
Makes
Filament Guide!
Z Screw Avoidance!
Possibly Ninjas in the Dark!
Version 2 Uploaded!
Gave a good bit more tolerance to everything, Tested on 2 machines that are close but not exact.
To install Just use the Z screws. They are plenty long enough.
Tighten a bit, then raise and lower the Z height to test for binding. Test at various heights Just like when it was built. get just tight enough that no binding occurs.
Clip your Filament at the 45 Degrees with the open face matching the bowd
Z Screw Avoidance!
Possibly Ninjas in the Dark!
Version 2 Uploaded!
Gave a good bit more tolerance to everything, Tested on 2 machines that are close but not exact.
To install Just use the Z screws. They are plenty long enough.
Tighten a bit, then raise and lower the Z height to test for binding. Test at various heights Just like when it was built. get just tight enough that no binding occurs.
Clip your Filament at the 45 Degrees with the open face matching the bowd
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in