Thingiverse
support for filament hanger
by Kmskelton
0
Downloads
0
Likes
0
Makes
I remixed my own rod holder. The adhesive wasn't strong enough to keep the rod holders attached to my filament box so I added triangles.
USE:
- print two of these
- cut a length of PVC pipe that is approximately 6mm (1/4") shorter than the width of the box that filament is stored in
- use an adhesive to adhere the spool holder to the walls of the filament box
- thread spools on pvc
- rest pvc on the holder
USE:
- print two of these
- cut a length of PVC pipe that is approximately 6mm (1/4") shorter than the width of the box that filament is stored in
- use an adhesive to adhere the spool holder to the walls of the filament box
- thread spools on pvc
- rest pvc on the holder
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in