Thingiverse
TUSH - One Piece "Push" Version
by kmccon
48
Downloads
31
Likes
1
Makes
This is a one piece version of Tush. Bearings (608's) are pushed up through the holes in the bottom of the bracket and then they snap in place.
It takes a little concentration to get them snapped into the center of the bearing. They snap easily over the outer race, but get a little tougher snapping into the inner race.
Bearings can be removed by continuing to push up out of the snap features.
I kept the infill low to allow better flexing of the snap features.
Also attached is the s
It takes a little concentration to get them snapped into the center of the bearing. They snap easily over the outer race, but get a little tougher snapping into the inner race.
Bearings can be removed by continuing to push up out of the snap features.
I kept the infill low to allow better flexing of the snap features.
Also attached is the s
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in