Thingiverse
Ender 2 split base
by GenCab
53
Downloads
27
Likes
0
Makes
Check out my etsy store. https://www.etsy.com/shop/HotSquare
11/9/2018 Updated
Per request:
-Base now available in 4 parts to allow printing on Ender 2.
-All joint sections reinforced and will require adhesive or cohesive for stability. Superglue or epoxy work well.
-Each section has a flat side for build plate but will require supports on all parts. Make sure and add plenty of shells. Recommend 4 perimeters minimum.
Works with old and new Ender 2 revisions. Its 4mm wider than the
11/9/2018 Updated
Per request:
-Base now available in 4 parts to allow printing on Ender 2.
-All joint sections reinforced and will require adhesive or cohesive for stability. Superglue or epoxy work well.
-Each section has a flat side for build plate but will require supports on all parts. Make sure and add plenty of shells. Recommend 4 perimeters minimum.
Works with old and new Ender 2 revisions. Its 4mm wider than the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in