Thingiverse
Stepper driver cooling channel with radial fan mount for Anycubic Kossel linear plus
by DIYTech
46
Downloads
25
Likes
0
Makes
Once I noticed how hot the stepper drivers on my 3D printer get I decided to design a fan shroud to cool them down. The fan motor is connected to the +FAN1 connector on my Anycubic Kossel linear plus with the stock firmware. This Port is going to be powered up as long as the motors are powered to.
The air channel itself is 115 mm long with an with of 15 mm and an height of 12 mm all measured on the inside. The bottom and all walls are 2 mm thick wich will make a total height of 14 mm.
The
The air channel itself is 115 mm long with an with of 15 mm and an height of 12 mm all measured on the inside. The bottom and all walls are 2 mm thick wich will make a total height of 14 mm.
The
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in