Thingiverse
Bath Tub Sink Drain Strainer(s) Hair-Trap
by ricktress
106
Downloads
71
Likes
0
Makes
Simple 40mm Bath Tub Drain Strainer. US Standard, can be scaled down (90% to fit the uncommon older standard 36mm drain).
01: Low profile with round holes, use a paperclip to remove unless you have tiny fingers.
02: High profile with rounded guards to minimize impact of stepping on it hard.
03: High profile without guards because it prints quicker and I don't step on it. It also has a small pin sized recess in the bottom for a thumbtack so you can turn it into a spinning top for a kids toy.
01: Low profile with round holes, use a paperclip to remove unless you have tiny fingers.
02: High profile with rounded guards to minimize impact of stepping on it hard.
03: High profile without guards because it prints quicker and I don't step on it. It also has a small pin sized recess in the bottom for a thumbtack so you can turn it into a spinning top for a kids toy.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in