Thingiverse
Pokemon Trainer Red 's Hat Emblem
by lordgarth6
29
Downloads
33
Likes
0
Makes
trainer reds hat emblem
this uses 3mm thick, 8mm diameter magnets and i found they fit flush with a little bit of force and no need for glue but thats all down to each persons printer.
I sanded the surfaces down a little and then put some enamel gloss on it so it feels smooth but keeps the layer look.
this uses 3mm thick, 8mm diameter magnets and i found they fit flush with a little bit of force and no need for glue but thats all down to each persons printer.
I sanded the surfaces down a little and then put some enamel gloss on it so it feels smooth but keeps the layer look.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in