Thingiverse
120mm Enclosure Exhaust Fan with SG90 controlled Door
by camelCase
8
Downloads
11
Likes
0
Makes
# 120mm Enclosure Exhaust Fan with SG90 controlled Door
Once I built an enclosure out of insulation board I found that the temperature inside the enclosure would keep rising, exceeding 60 deg C.
I wanted to add a fan to the enclosure, with a servo controlled door which would close when possible to reduce drafts while printing ABS.
The construct is designed to sit on top of the enclosure, with a semi circle hole cut into the roof.
The front has a small compartment to house the electro
Once I built an enclosure out of insulation board I found that the temperature inside the enclosure would keep rising, exceeding 60 deg C.
I wanted to add a fan to the enclosure, with a servo controlled door which would close when possible to reduce drafts while printing ABS.
The construct is designed to sit on top of the enclosure, with a semi circle hole cut into the roof.
The front has a small compartment to house the electro
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in