Thingiverse
JG Aurora Z-603S Rear Filament Guide
by leetneko
3
Downloads
3
Likes
0
Makes
This is a replacement for the rear filament guide/cable clamp for the JG AURORA Z-603S. I wanted to make sure i had a backup in case i needed a new one.
It's a 90% exact copy of the original that came with the printer, all i changed was the width of the block (so the holes dont run off the edge), and i recessed the heads of the screws a bit more.
It's a 90% exact copy of the original that came with the printer, all i changed was the width of the block (so the holes dont run off the edge), and i recessed the heads of the screws a bit more.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in