Thingiverse
Fire Resistant 3D Print Enclosure
36
Downloads
27
Likes
0
Makes
This is a quick run through of the 3D print enclosure I built for my Prusa MK3.
In short, the sides of the enclosure are hardie backer (cement board); $11 a sheet from Home depot and took 2.5 sheets. The frame is 2x2, which was about $2 per 8 ft section. I think I used like 5 or 6 of those? The glass is just 1/8 inch regular glass $20. The vents I used can be found here:
The fan/hose adapter I used is this one: www.thingiverse.com/thing:2297772
See the following for my designs (info for
In short, the sides of the enclosure are hardie backer (cement board); $11 a sheet from Home depot and took 2.5 sheets. The frame is 2x2, which was about $2 per 8 ft section. I think I used like 5 or 6 of those? The glass is just 1/8 inch regular glass $20. The vents I used can be found here:
The fan/hose adapter I used is this one: www.thingiverse.com/thing:2297772
See the following for my designs (info for
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in