Thingiverse
Snapmaker Enclosure Thread Guide
by jnovack
19
Downloads
15
Likes
0
Makes
I was having some trouble with the Snapmaker enclosure pulling a lot of PLA off the spindle. It looked sloppy and because of the twists it was causing issues.
Now, you can see the PLA feed stays taut and neat.
This thing was made with Tinkercad and printable on the Snapmaker.
https://www.tinkercad.com/things/iIsVmdd72fX
*Update* - My initial issue (which caused this Thing) may have been that the plastic tube/chute was not resting close to the roll as it should have been, permitting
Now, you can see the PLA feed stays taut and neat.
This thing was made with Tinkercad and printable on the Snapmaker.
https://www.tinkercad.com/things/iIsVmdd72fX
*Update* - My initial issue (which caused this Thing) may have been that the plastic tube/chute was not resting close to the roll as it should have been, permitting
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in