Thingiverse
Anet A8 Table Mount - Quick and Dirty ;)
by Echloton
9
Downloads
4
Likes
0
Makes
Additional material needed:
8x Screws 3mm diameter (dependend on your base/bottom material)
Quick and dirty table mounts for the Anet A8 Printer. This was a 10min print with low resolution, but still yet the best optimization in noise/vibration terms!!! The printer is almost silent now, compared to the state before.
***Installation:***
1. Print Part four times (4x)
2. "Clip" mounts on the threaded shaft
3. Mark down the position of the screw holes (or directly drill the holes [e.g. 2mm
8x Screws 3mm diameter (dependend on your base/bottom material)
Quick and dirty table mounts for the Anet A8 Printer. This was a 10min print with low resolution, but still yet the best optimization in noise/vibration terms!!! The printer is almost silent now, compared to the state before.
***Installation:***
1. Print Part four times (4x)
2. "Clip" mounts on the threaded shaft
3. Mark down the position of the screw holes (or directly drill the holes [e.g. 2mm
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in