Thingiverse
ECX circuit servo saver
by jonnyg30
13
Downloads
10
Likes
0
Makes
Noticed the steering was getting very sloppy on my ECX Circuit stadium truck so I quickly knocked up and printed a new servo saver steering block. Steering is now spot on!
I'd probably say PLA may be a bit stiff for this job and liable to snap if you smack the front wheels hard enough or not provide enough give to save the servo.......but I could be wrong!
printed in ABS at 100% infill, no supports needed, only takes a few minutes to print and slower is better. may need some slight adjustm
I'd probably say PLA may be a bit stiff for this job and liable to snap if you smack the front wheels hard enough or not provide enough give to save the servo.......but I could be wrong!
printed in ABS at 100% infill, no supports needed, only takes a few minutes to print and slower is better. may need some slight adjustm
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in