OctoPrint Raspberry Pi Rig 3.5" PiTFT Touch Display for Lulzbot Mini

This case was remixed from the Adafruit OctoPrint Raspberry Pi Rig to allow it to be mounted to the side of a Lulzbot Mini 3D Printer. Although the bottom holes of the case line up with preexisting holes on the printer, the top holes will need to be drilled out with a 31 drill bit. The case is secured to the printer using 10mm M3 screws with nylock nuts.

Original case and information:
https://learn.adafruit.com/3-dot-5-pitft-octoprint-rig/3d-printed-case

Guide for setup:
https://learn.a