Thingiverse
Anet A8 side/rear light bar
by niki_m
12
Downloads
8
Likes
0
Makes
This is a side/rear light bar for the Anet A8 (and similiar) printers.
It will comfortably fit two rows of LED strips and mounts to the 2 lower screws that hold the power supply (original screws still fit).
The power cable can be fed through a hole in the bottom, where the wires can then be connected directly to the power supply.
It will comfortably fit two rows of LED strips and mounts to the 2 lower screws that hold the power supply (original screws still fit).
The power cable can be fed through a hole in the bottom, where the wires can then be connected directly to the power supply.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in