Coral Frag Rack Foot

This is a foot that can be used with standard egg crate to make custom Frag Racks. Print with ABS or some other Reef Safe Filament ONLY. If the fit isn't snug enough you can use a bit of superglue gel to glue the feet into place.

Feet are 1/2" in Diameter by 1-1/4" tall, and hold the frag rack (Egg Crate) 1 inch above the bottom of your bare-bottom reef tank or frag tank.

Print with 100% fill so the feet aren't too buoyant.

Since it is tall with a small base, print with a brim or ra