Thingiverse
Mega Man Buster Lamp
by arvic3d
40
Downloads
47
Likes
1
Makes
Mega Man Buster designed around the Ikea Hemma lamp kit (https://www.ikea.com/us/en/catalog/products/70312324/).
First, the lamp base screws into the bottom half, then you can screw in the lightbulb, and finally place the top half on and plug in!
This one was printed with eSun PETG, but next time I would probably just print with translucent PLA.
You don't need to worry about heat melting the print because the bulb is LED and doesn't give off much heat.
Features:
* Slot in the rear t
First, the lamp base screws into the bottom half, then you can screw in the lightbulb, and finally place the top half on and plug in!
This one was printed with eSun PETG, but next time I would probably just print with translucent PLA.
You don't need to worry about heat melting the print because the bulb is LED and doesn't give off much heat.
Features:
* Slot in the rear t
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in