Thingiverse
ANYCUBIC i3 mega glue stick holder
16
Downloads
6
Likes
0
Makes
made on tinkercad!
I got tired of always losing my glue sticks so I did something about it
printed on a ANYCUBIC i3 mega with supports at 0.2mm layer height
Note I had to drill out the holes a little in order fit and even had to cut out on of the holes In order to use all 4 screws also there is a intentional week point on the sides. you can see in the pictures were it is. This is to give a bit of tension on the glue sticks in order for them to stay in frimly an not just fly out
I got tired of always losing my glue sticks so I did something about it
printed on a ANYCUBIC i3 mega with supports at 0.2mm layer height
Note I had to drill out the holes a little in order fit and even had to cut out on of the holes In order to use all 4 screws also there is a intentional week point on the sides. you can see in the pictures were it is. This is to give a bit of tension on the glue sticks in order for them to stay in frimly an not just fly out
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in