Thingiverse

FrSky X-LITE Stick Caps / Extenders

by Mike-vom-Mars

26 Downloads

15 Likes

0 Makes

Download Model

frsky FrSky Taranis FrSky X-lite stick cap stick extender Stick Extension taranis xlite Thumbstick extension x-lite xlite frsky FrSky Taranis FrSky X-lite stick cap stick extender Stick Extension taranis xlite Thumbstick extension x-lite xlite

#X-LITE Stick Caps / Extenders

The original sticks are a bit small and do not provide a good thumb contact area for my personal taste, so I created these simple caps.

####Hint:
>If the caps do not fit tightly on your sticks (this may slightly vary depending on the filament used), just scale them a little bit (at about 1% should do it).

####Print Settings:
>- Layer height: 0.2mm
>- Use supports (build plate only), 5mm support line distance
>- Infill: 8%
>- Use a raft for good adhes

Source

Thingiverse

Comments

Makes