Thingiverse
Nicky Clarke Hairdryer Attachment (Thing)
5
Downloads
4
Likes
0
Makes
My significant other came to me with a broken hairdryer end piece.
It was in pieces and could not be glued so I decided to design and print a replacement.
Printed in ABS for the Nicky Clarke NHD104
I have only tested this so far on a cold setting and not stupid hot, so I cannot vouch for its suitability on a hot setting.
Your mileage may vary and I will not be held responsible for your partners reaction to melted plastic (unless thats the specific look they are going for) in their hair
It was in pieces and could not be glued so I decided to design and print a replacement.
Printed in ABS for the Nicky Clarke NHD104
I have only tested this so far on a cold setting and not stupid hot, so I cannot vouch for its suitability on a hot setting.
Your mileage may vary and I will not be held responsible for your partners reaction to melted plastic (unless thats the specific look they are going for) in their hair
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in