Thingiverse
TronXY X1 Spool Holder (Print without support)
by GreenRider
30
Downloads
28
Likes
0
Makes
I have searched all over thingiverse for a good spool holder for my Tronxy X1 and after printing several failed designs (one bends, the other doesn't fit...) I designed my own spool holder.
This design prints faster than others that I have tried because it is partially hollowed out, but it is strong enough to hold a full 1kg spool without bending.
No support needed!
Instructions:
1)Print the spool holder and the end cap.
2)Screw the spool holder to the top of your Tronxy X1 using the
This design prints faster than others that I have tried because it is partially hollowed out, but it is strong enough to hold a full 1kg spool without bending.
No support needed!
Instructions:
1)Print the spool holder and the end cap.
2)Screw the spool holder to the top of your Tronxy X1 using the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in