Thingiverse
Featherlight Falcon Pod (Work In Progress)
by jdmkramer
3
Downloads
6
Likes
0
Makes
An actual Falcon for your Falcon Multirotors Featherlight. It should work with any size, but I designed it for my 5"
From the [Rotorbuilds Page](https://rotorbuilds.com/build/12682):
This is my first attempt at a full coverage 3d printable pod. It prints sort of folded open with a living hinge that is actually quite sturdy despite its appearance. It is designed around a 20x20 stack, Runcam Split Mini, and an 18x18 gps with long range in mind. Immortal T mounts acrorss the rear legs and room
From the [Rotorbuilds Page](https://rotorbuilds.com/build/12682):
This is my first attempt at a full coverage 3d printable pod. It prints sort of folded open with a living hinge that is actually quite sturdy despite its appearance. It is designed around a 20x20 stack, Runcam Split Mini, and an 18x18 gps with long range in mind. Immortal T mounts acrorss the rear legs and room
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in