Thingiverse
Anet A8 AM8 Control board and FET Driver board enclosure
by Jsschlat
176
Downloads
100
Likes
2
Makes
Update: Apr 10, 2020
I added a reset lever to the base design. The lever simply slides into the air holes in the side of the case and snaps into place. The "block" on the outside goes up to prevent the lever from sagging and touching any other components (FET driver boards in my case). This will only work for a RAMPS 1.x board installation. If I recall correctly, the Anet A8 reset was on the top and middle of the board.
I also uploaded all the .STP files for the V3 case, cover, and re
I added a reset lever to the base design. The lever simply slides into the air holes in the side of the case and snaps into place. The "block" on the outside goes up to prevent the lever from sagging and touching any other components (FET driver boards in my case). This will only work for a RAMPS 1.x board installation. If I recall correctly, the Anet A8 reset was on the top and middle of the board.
I also uploaded all the .STP files for the V3 case, cover, and re
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in