Anet A6 Spool Holder Filament Guide

Here is a Spoolholder with two versions of filament guides (one closed and the other open).

You can only print the spoolholder if you want.

I designed it specially for this design of z-axis top plates with M8 support: https://www.thingiverse.com/thing:2675116, because after this and using this SD Card Holder: https://www.thingiverse.com/thing:2457079 I had not enough space for other spoolholders which are mounted at the Anet.

It could also be the solution for every other design, if you want your spool direct on top of the Anet.

The filament guide is flat, because of easier printing without support. You can heated up a little bit and bend it like you want. Very easy and worked perfect as I made it.

You can fix the original Spoolholder of the Anet A6 with up to six M3 screws at the designed spoolholder and fix it with nuts at the bottom.

The two holes at the front of the spoolholder are for the filament guide and gets also fixed with M3 screws. The holes are 2,9mm so y