Thingiverse
Pump Cover for a Hayward
by kevintwilson
16
Downloads
10
Likes
0
Makes
This replaces the original Black Cap piece (white here in the image) and not the clear cap.
Printed 50% Infill for strength. PLA
Full Supports - didn't want take a risk due to the Tight Fit Needed for this to work.
Just snap the clear part inside, then put it on the Pump. IF there is any leaking you just need to turn it slightly. This turns better then the orginal which means it isn't as Tight, But once it is aligned correctly, no issues.
Took 17 hours to print. Flat Side Down.
Printed 50% Infill for strength. PLA
Full Supports - didn't want take a risk due to the Tight Fit Needed for this to work.
Just snap the clear part inside, then put it on the Pump. IF there is any leaking you just need to turn it slightly. This turns better then the orginal which means it isn't as Tight, But once it is aligned correctly, no issues.
Took 17 hours to print. Flat Side Down.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in