Thingiverse
Glass Plate Holder Long for 3mm Plate
by ggiavelli
31
Downloads
15
Likes
0
Makes
long piece to hold a glass plate to a bed (220mm or wider)
Has two 5mm screw holds for underneath clamping. Or print the version with 3d Printed screws.
Designed to fit snug. Print with center hole facing the sky or for max strength print vertical
The hole is 6.9mm
The length is 140mm
-- make screw holes 0.4mm larger, too small for 5mm - done. updated thread pitch to work better. DONE
Tip: to make it tight without screws, put a piece of kapton or electric tape inside the slo
Has two 5mm screw holds for underneath clamping. Or print the version with 3d Printed screws.
Designed to fit snug. Print with center hole facing the sky or for max strength print vertical
The hole is 6.9mm
The length is 140mm
-- make screw holes 0.4mm larger, too small for 5mm - done. updated thread pitch to work better. DONE
Tip: to make it tight without screws, put a piece of kapton or electric tape inside the slo
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in