Thingiverse
Adafruit Universal Qi Wireless Charging Base
by Sixtus
0
Downloads
1
Likes
0
Makes
A charging base for the Adafruit "UNIVERSAL QI WIRELESS CHARGING TRANSMITTER".
Can use low or high resolution to print this, seems to fit the charger on either.
Open hole for the charging plate so you can put the phone on the top, push the coil up flat to the phone and then hotglue in place, approximately 2mm of play to seat properly.
The charging circuit was fixed in place with some two sided foam tape, originally was going to use hot glue as well.
Using a white, or translucent m
Can use low or high resolution to print this, seems to fit the charger on either.
Open hole for the charging plate so you can put the phone on the top, push the coil up flat to the phone and then hotglue in place, approximately 2mm of play to seat properly.
The charging circuit was fixed in place with some two sided foam tape, originally was going to use hot glue as well.
Using a white, or translucent m
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in