Thingiverse
NinjaFlex/Cheetah minimalist spool holder
by IvanNik42
5
Downloads
7
Likes
0
Makes
A holder for the NinjaFlex/Cheetah spools.
52mm (internal spool hole) X 22 mm (out bearing diameter)
I don't like all these "universal" holders. This holder is especially for 52mm spools and 22mm 608 ball bearing (8x22x7mm).
Holder fits perfectly with some pressure (use vise or rubber hammer)
- Allows the spools to spin freely
- Must have for flexible filament
- Minimalist design, no nuts are required for spool support
- Low printing quality requirement = fast printing
Us
52mm (internal spool hole) X 22 mm (out bearing diameter)
I don't like all these "universal" holders. This holder is especially for 52mm spools and 22mm 608 ball bearing (8x22x7mm).
Holder fits perfectly with some pressure (use vise or rubber hammer)
- Allows the spools to spin freely
- Must have for flexible filament
- Minimalist design, no nuts are required for spool support
- Low printing quality requirement = fast printing
Us
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in