Thingiverse
Silicone sock mold for Geeetech i3 original heating block
by valand70
17
Downloads
7
Likes
0
Makes
This is a mold to make a silicone sock for Geeetech original heating block 20x18x10mm.
It is a full sock, for the heating element and thermistor there are holes, so to install it the first time you have to get the resistor and thermistor off.
When you need to take it off, just slide it along the wires.
I made it like this because it wear much better on the block than the commercial ones that can be placed without removing the resistor. I guess it also helps keeping more heat inside...
The
It is a full sock, for the heating element and thermistor there are holes, so to install it the first time you have to get the resistor and thermistor off.
When you need to take it off, just slide it along the wires.
I made it like this because it wear much better on the block than the commercial ones that can be placed without removing the resistor. I guess it also helps keeping more heat inside...
The
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in