Thingiverse
X-axis belt gear cover
by ukflyer
81
Downloads
30
Likes
0
Makes
This is a replacement X axis belt gear cover for a Creality CR-10S.
The reason behind the design is that I have fitted vibration dampers to the X & Y axis on my CR-10 S4. These are attached at two points (in my case top left and bottom right as you face the printer) on the X carriage and two points on the stepper motor. The problem with the original X-axis cover is that when the you tighten the vibration dampers through the cover it can, and does, cause the cover to crack under the stress.
The reason behind the design is that I have fitted vibration dampers to the X & Y axis on my CR-10 S4. These are attached at two points (in my case top left and bottom right as you face the printer) on the X carriage and two points on the stepper motor. The problem with the original X-axis cover is that when the you tighten the vibration dampers through the cover it can, and does, cause the cover to crack under the stress.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in