Thingiverse
Hammock bug net spreading clip (v2)
by Stansoid
5
Downloads
4
Likes
0
Makes
This is a clip I designed to connect to each of the six points on my hammock where the bug netting is held up by overhead paracord.
The idea behind this is the clip will allow me to tie a stick that I find in the feild to spread the bug netting open so the center is not hanging down in my face.
I have not tested this yet. I am currently printing one clip to see if the print will work.
Once I get it finalized and get six printed, I will test it on the hammock and either post pictures
The idea behind this is the clip will allow me to tie a stick that I find in the feild to spread the bug netting open so the center is not hanging down in my face.
I have not tested this yet. I am currently printing one clip to see if the print will work.
Once I get it finalized and get six printed, I will test it on the hammock and either post pictures
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in