Thingiverse
DRZ Rear Blinker Mount Bracket
by Pomerinke
11
Downloads
9
Likes
0
Makes
One of the aluminum brackets for the rear blinkers on my DRZ400sm snapped. I used zip ties to put the blinker back on, but the inspector told me that wasn't allowed. So I took some measurements and made a new one that I'm going to have printed.
The piece is 3mm thick, just as the stock aluminum. I also added slots instead of a single hole so it can be adjusted.
Note: the notch at the long end is a mistake that I didn't fix because it has no bearing on the completed part.
The piece is 3mm thick, just as the stock aluminum. I also added slots instead of a single hole so it can be adjusted.
Note: the notch at the long end is a mistake that I didn't fix because it has no bearing on the completed part.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in