Thingiverse
Tronxy X5S v2 bearing liners
by jpnurro
23
Downloads
16
Likes
0
Makes
Tronxy has fixed some belt line issues with the X5S v2 but only to half way.
The belt liner are made with the metallic bigger washer and smaller split lock washers on the both sides of bearing allowing it rotate. At least I couldn't get the bearings in line because the locking washers won't go totally flat leaving the bearings tilted.
The other issue is that middle bar roller bearings are running at bit higher than the corner bearings. This cause belt rubbing with the liner washer.
I
The belt liner are made with the metallic bigger washer and smaller split lock washers on the both sides of bearing allowing it rotate. At least I couldn't get the bearings in line because the locking washers won't go totally flat leaving the bearings tilted.
The other issue is that middle bar roller bearings are running at bit higher than the corner bearings. This cause belt rubbing with the liner washer.
I
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in