Thingiverse
Raise3D - N2 Plus - Filament Run-Out Sensor - Holder
32
Downloads
22
Likes
1
Makes
On the original installation instructions the sensor is fixed with tape inside the printer and the filament for the left extruder must be loaded into the right sensor input.
With the new holder the sensor is fixed with screws and the filament for the left extruder could also be loaded into the left sensor input.
How to install the new sensor holder:
- print all parts
- use the drilling template and drill four holes (4mm diameter) and sink it
- screw the main holder to the printer ("Printi
With the new holder the sensor is fixed with screws and the filament for the left extruder could also be loaded into the left sensor input.
How to install the new sensor holder:
- print all parts
- use the drilling template and drill four holes (4mm diameter) and sink it
- screw the main holder to the printer ("Printi
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in