Tamiya 12mm Hex Converter
90
Downloads
61
Likes
2
Makes
This will work on vintage Tamiya buggies like Grasshopper, Hornet, Grasshopper II, Wild One and many many others.
This is a small remix of the 12mm Hex converter by Engineer6. I found it binded around the axle when tightening up the rear wheel so added a small lip (same design as the original adaptor), which gets pushed against the bearing rather than the axle casing and leaves some tolerance.
Added another version which is 1mm longer as I found when this was fitted to my Wild One, it was
This is a small remix of the 12mm Hex converter by Engineer6. I found it binded around the axle when tightening up the rear wheel so added a small lip (same design as the original adaptor), which gets pushed against the bearing rather than the axle casing and leaves some tolerance.
Added another version which is 1mm longer as I found when this was fitted to my Wild One, it was
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in