Thingiverse
Titan Idler Arm for Grove Bearing
by Hagster
32
Downloads
26
Likes
0
Makes
A modified idler arm for Titan extruder clones.
Also a new base plate (Aero only) that has been modified to make the hob gear align better with the filament path.
I used 2 off M5 brass nuts for the stepper pivot. These have a 7.85mm width(flat to flat). Each nut is about 3.5 to 4mm thick. Install both nuts then drill them smooth with an 5mm drill. This rotates much more smoothly than ABS or PLA will.
Also a new base plate (Aero only) that has been modified to make the hob gear align better with the filament path.
I used 2 off M5 brass nuts for the stepper pivot. These have a 7.85mm width(flat to flat). Each nut is about 3.5 to 4mm thick. Install both nuts then drill them smooth with an 5mm drill. This rotates much more smoothly than ABS or PLA will.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in