Thingiverse
Hepa Filter Exhaust Fan
by RDTymko
3
Downloads
4
Likes
0
Makes
Printed on a Prusa MK3 Using The Half Filter setup then bonded together.
Uses M4 Screws to assemble all the pieces tight together.
Setup To use 92mm 120v fans and M4 Screws. No Threaded inserts needed.
You may need to clean the screw holes. They are a tight fit.
I added the on/off switch after the fact which is why it is not on the STL.
Uses M4 Screws to assemble all the pieces tight together.
Setup To use 92mm 120v fans and M4 Screws. No Threaded inserts needed.
You may need to clean the screw holes. They are a tight fit.
I added the on/off switch after the fact which is why it is not on the STL.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in