Thingiverse
BLTOUCH remixed mount for Anycubic Kossel Pulley
by Enochj
15
Downloads
2
Likes
0
Makes
Remixed as I was having effector tilt issues as the rods were hitting the support fot the BLTouch.
Rough job in tinkercad but seems to have fixed the problem.
The bigger problem was that I hadn't erased the eprom so when I changed the probable radius in the source to avoid hitting the mount it was still probing to the old radius. the tilting problem compounded. Once I erased the EEPROM and did the G33 to a much smaller area it was all better.
Rough job in tinkercad but seems to have fixed the problem.
The bigger problem was that I hadn't erased the eprom so when I changed the probable radius in the source to avoid hitting the mount it was still probing to the old radius. the tilting problem compounded. Once I erased the EEPROM and did the G33 to a much smaller area it was all better.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in