Orignal Prusa MK3 using Igus RJZM-01-08 bearings

I modified the original Prusa MK3 scad files for x-carriage,x-carriage-back,x-end-idler and x-end-motor to accommodate for the bigger Igus RJZM-01-08 bearings (16mm not 15mm like stock)

All parts should be printed using PETG filament.

The Bearing holder replaces u bolt holding the bearings on the Y axis. Its should be printed with 70% infill. Also you will need 6 M3 18 mm screws.

TIPS: If your Bearing are sticking use some Silicone Grease. The sticking can cause XYZ calibration issue.