Thingiverse
iPhone6Plus & Apple Watch Charging Stand
by IgottaFind
12
Downloads
13
Likes
0
Makes
Created in SolidEdgeST10.
I only built "Base-0_001.stl".
"Base-Revision-0_001.stl" is a model change I made to allow access to the side buttons and head phone jack (Please note, I have not printed it).
Layer Height: 0.15mm
Approx Filament Used: 44m
20% Infill, No Supports.
17 hours, 12 minutes to print.
Nozzle Temp: 200°C
Bed Temp: 65°C.
As printed, the Apple Watch charging puck fit perfectly. The phone charging cable, did not, I had to open it up with a drill.
The revision file
I only built "Base-0_001.stl".
"Base-Revision-0_001.stl" is a model change I made to allow access to the side buttons and head phone jack (Please note, I have not printed it).
Layer Height: 0.15mm
Approx Filament Used: 44m
20% Infill, No Supports.
17 hours, 12 minutes to print.
Nozzle Temp: 200°C
Bed Temp: 65°C.
As printed, the Apple Watch charging puck fit perfectly. The phone charging cable, did not, I had to open it up with a drill.
The revision file
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in