Thingiverse
Double din to Single din with aux switch mount hole
by DustyDingus
40
Downloads
35
Likes
0
Makes
Remixed to fit my 2003 Ford Ranger because I needed a place to mount the switch for my new Off-Road lights.
I am using a rear support on the receiver from my previous universal double din adapter kit, as well as the bezel that came with my receiver.
The clips could be better, but do a good job of holding it in there as is. Whenever I get around to adding more switches and replacing this again I will improve upon that.
The switch mount hole is sized at 20.5 mm diameter to fit the swi
I am using a rear support on the receiver from my previous universal double din adapter kit, as well as the bezel that came with my receiver.
The clips could be better, but do a good job of holding it in there as is. Whenever I get around to adding more switches and replacing this again I will improve upon that.
The switch mount hole is sized at 20.5 mm diameter to fit the swi
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in