Thingiverse
Nema17 motor and pully mount for 3060 profile slider
by Steadirob
4
Downloads
2
Likes
0
Makes
I made this set of motor support and pulley support, to drive a linear slider build on 3060-profile
This works with a Nema 17 stepper motor, which is slightly underpowered, however, I want to upgrade this to a 2 motor system, one on either side.
For now the maximum load is about 5-8 kg, and then the speed is limited.
The motor / pulley part fits into the profile slots, the clamp part is the same for both.
Needed: 4 M4 screws 50mm long.
This works with a Nema 17 stepper motor, which is slightly underpowered, however, I want to upgrade this to a 2 motor system, one on either side.
For now the maximum load is about 5-8 kg, and then the speed is limited.
The motor / pulley part fits into the profile slots, the clamp part is the same for both.
Needed: 4 M4 screws 50mm long.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in