Thingiverse
Mount for TBS UNIFY PRO 5G8 HV
by rdennisak
12
Downloads
6
Likes
0
Makes
A basic mount/holder for the TBS Unify HV video transmitter. I made it without a bottom so that air can circulate more freely.
Designed for my specific build, there is a cutout for the SMA cable when it has been doubled back on the other side from the u.fl connector. If you run the cable straight out, you can just cut out an opening for it with an xacto knife.
Should work with either PLA or TPU, but PLA tends to distort when it gets heated up by the transmitter.
Designed for my specific build, there is a cutout for the SMA cable when it has been doubled back on the other side from the u.fl connector. If you run the cable straight out, you can just cut out an opening for it with an xacto knife.
Should work with either PLA or TPU, but PLA tends to distort when it gets heated up by the transmitter.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in